Every safety recall published by the Australian government, searchable and filterable.
Under extreme braking conditions the affected ABS modules may lose all brake fluid from front braking circuit.
The side airbag warning light may inadvertently become activated, due to several possible problems associated with wiring connectors fitted on these vehicles.
There have been instances of the steel ball in ports 1 and 2 on the interlock valve coming loose which may lead to the parking brake being applied.
The plastic fuel lines may not be secured properly and can be damaged.
Part Nos. 66693-98 and 66680-98: the rear brake pedal could come in contact with some Screamin Eagle Race Brace supports which could limit the travel of the rear brake pedal thus p…
Abrasion, leading to possible fuel leakage can occur between the fuel line and accessory custom horn cover.
The backrests could under certain conditions, inadvertently detach from their front mounts. This could cause the passenger to shift his/her position, possibly resulting in persona…
The driver's side knee bolster assembly may have been improperly installed. As a result, the knee bolster could separate from the upper instrument panel and fall onto the driver's…
In extreme circumstances the anti-roll bar clamp could break. A noise from the front suspension could be apparent under this condition.
There is a risk that an electrical fault in the ABS control unit can possibly cause overheating of certain components which in some cases could lead to fire.
Not provided with the Australian Design Rule (ADR) 37/01 mandated 'Unleaded Fuel Use Only' label during production.
Have been fitted with incorrectly manufactured crankshaft position sensors which could lead to engine stalling.
If the seatbelt pre tensioner of the front occupant seats deploys in an accident, there is a possibility that due to a manufacturing discrepancy, the pre tensioner manifold cap cou…
Could have been built with cracked front mounts on the rear shock absorber. This defect could potentially lead to sudden change in suspension height without prior warning, thus po…
Some of the affected ball socket assemblies may wear out prematurely, leading to a potential separation, which could result in partial, or total loss of steering control.
It is possible for seat belt pre-tensioner units to activate unnecessarily when the ignition is switched on.
Due to insufficient length of the cruise control cable there is a likelihood that the vehicle accelerator may cause the vehicle to inadvertently increase speed.
The lower portion of the Driver Side Airbag Cover (horn pad) may become detached from the airbag module during deployment. In the worst case, there is a possibility that the detac…
The engine compartment wiring loom may chafe on the thermostat housing bolt. This chafe condition, if not attended to, may result in damage to the wiring loom.
The front suspension lower ball joint may not be retained in the knuckle assembly under all circumstances. Excessive kerbing or grounding of the vehicle may cause the ball joint t…
The accelerator pedal base plate may crack around the hinge pin area.
Faulty throttle body cable lever.
Possibility of incomplete welding on the steering handlebar.
There may be a possibility that the clutch cable fitted to some vehicles within model range may become frayed.
There is a possibility that the crankshaft pulley bolt may come loose. In the worst case this may result in the pulley spinning on the crankshaft rendering the power steering pump…