Every safety recall published by the Australian government, searchable and filterable.
The door harness wires on both the driver and passenger doors could be damaged or cut by the repeated motion of opening or closing the doors.
Due to an incorrect manufacturing process, a component within the fuel pump could swell, causing the fuel pump to become inoperative.
Due to an incorrect manufacturing process, a component within the fuel pump could swell, causing the fuel pump to become inoperative.
If there is liquid or liquid droplets on the rear seat control display, the system may perceive this as a constant touch.
The transmission oil cooler (TOC) hose may have been manufactured with incorrectly cured rubber. This rubber can rupture, allowing transmission fluid to leak.
Some of the bearing cups in the front and/or interaxles have been assembled without a thrust washer. If the vehicle is operated under these conditions, the universal joint may ulti…
In some vehicles the signal from the crankshaft position sensor may fail. This may result in an engine stall (loss of engine power), as well as loss of the ability to restart the e…
The door harness wires on both the driver and passenger doors could be damaged or cut by the repeated motion of opening or closing the doors.
The internal components of the fuel pump may wear and fracture the welded area of the fuel pump, which could lead to a fuel leak in the engine compartment.If this was to occur, veh…
Due to a manufacturing fault in the hydraulic unit brake booster, panic braking could cause loss of brake power assistance and the Anti-lock Braking System (ABS) without prior warn…
Due to a manufacturing issue with the vehicle's dash panel, the front passenger airbag may not fully inflate in the event of an accident.
In cold ambient temperatures, the DC-DC converter may shut down and prevent the 12-volt battery from recharging, resulting in a loss of drive power if the vehicle continues to be d…
The speed sensor power supply circuit may experience corrosion. The corrosion may cause the speed sensor to lose power supply and could result in the speedometer and odometer not w…
The clamping nuts on the rear-axle trailing arm may break over the service life of the vehicle, as they may not have been manufactured within specification.
The fuel delivery pipes on the 2.5T GDI engines may be defective and fuel may leak out of the pipes.
The dashboard may not have been bonded together properly.
The spark plugs in vehicles may not meet specification. As a result the spark plugs may fail during regular use.
Due to a software issue, the automatic network search of the emergency call system (eCall) communication module may be deactivated. In this case, the automatic and manual emergency…
The fuel hose may come into contact with the engine. This may lead to fuel hose wear and a fuel leak.
Due to improper Engine Control Module (ECM) programming, the ignition coil may overheat, creating a short circuit which may blow the ignition coil fuse.
The wheel hub covers may not have been manufactured correctly and may detach from the wheel hub.
The rear stabiliser bracket bolts may not have been sufficiently tightened during production. In this case, the bolts may become loose over time and/or fall out during normal vehic…
Due to a manufacturing error, an electronic control circuit board in the Anti-Lock Braking System (ABS) module may short circuit when the components are exposed to moisture.
Due to a manufacturing error, an electronic control circuit board in the Anti-Lock Braking System (ABS) module may short circuit when the components are exposed to moisture.