Every safety recall published by the Australian government, searchable and filterable.
Due to possible caulking on the cable tip at the centre drum being improperly shaped, the tip may get caught in a stanted direction against the groove in the parking brake lever du…
The Left Rear and Right Rear brake pipes may have been connected to the ABS Hydraulic unit in reverse sequence. The secondary brake tube between the master cylinder and the ABS Hyd…
A possibility exists that the front bumper beam may have insufficient strength when subjected to high towing load 'recovery' techniques(snatch strap) from soft ground such as sand,…
During product monitoring on R1200GS,R1200RT and R1200ST motorcycles it has been determined that there is the possibility of small objects such as a pebble, for example, or the cov…
Under the influence of increased loads the steering arm mounting brackets may have a reduced service life. This is particulaly so if the steering end stop limit has not been adjust…
On the top of the tyre placard states correct usage of a 185/60R15-88 (G) type tyre. However on the bottom placard incorrectly refers to a different load and speed rating of (93) (…
The television may continue to operate if the telephone is used while the vehicle is stationary. The television operation could distract the driver and is a breach of the ADRs.
The anti-theft wheel locking bolt kit needs to be replaced to eliminate the risk of damage to the bolts making it more difficult to remove the wheel using the anti theft key.
There is a possibility that the tyre bead may have been damaged during the process of mounting the tyre on to the wheel.
The turbocharger has caused increased blow-by and high crankcase pressure during exhaust braking, which in turn caused over revving of the D16 engine.
Mechanical loads exerted in the backrest heating for the front seats when persons get into or out of the vehicle may result in damage to the seat heating element in the backrest pa…
The fuel shut off valve was not manufactured properly and as a result the 'on' and 'reserve' postions were reversed. This could lead to the vehicle unexpectedly running out of fuel…
The seat base attachment screws may not have been sufficiently tightened during production. It is possible that this the occupants of the vehicle if in an accident may not be secur…
Potential lack of grease and incorrect torque of the front bearings.
Heat deterioration may occur inside of the Catalytic Converter when it is repeatedly attacked by excessively high thermal load. This could result in Breakage of the Catalytic Conve…
Heat deterioration may occur inside of the Catalytic Converter when it is repeatedly attacked by excessively high thermal load. This could result in Breakage of the Catalytic Conve…
The fuel tank inlet pipe and breather tube of the subject vehicles may leak due to a pinhole caused by corrosion.
An incorrect turn signal was installed.
An oil leak from the rocket covers on D9 engines has occured.Vehicles affected: Buses equipped with DSC9 11, DSC9 12,DSC9 13 and DSC9 15 engines. (all to Euro 2 specifications).
Due to improper moulding of the impeller of the electric fuel pump, alcohol contained in the fuel may cause impeller to distort and contact the fuel pump body resulting in seizure…
An oil leak possibly exists from the pinion oil seal which if not rectified could eventually lead to loss of oil and possible seized rear wheel.
Risk of a lack of tightening pressure of the steering wheel mounting nut. This could potentailly affect the control of the vehicle.
There is a possibility that the tyre bead may have been damaged during the process of mounting the tyre onto the wheel. This damage may lead to loss of tyre air pressure.
A potential exists for the throttle to bind.
The fitment of the ASCD accessory has been found to be subject to a number of fitment quality issues, the most severe of which may result in the vehicle throttle cable becoming stu…