Every safety recall published by the Australian government, searchable and filterable.
The wheel hub covers may not have been manufactured correctly and may detach from the wheel hub.
The motorcycle's engine valve guides may experience excessive, premature wear, and become damaged over time.
There may be insufficient engagement of the parking brake, due to excessive internal tolerances of the rear brake calipers.
The motorcycle's side stand mounting bracket may become damaged over time. The side stand may fail when the motorcycle is parked.
The eMMC may malfunction over time.If a malfunction occurs:1. The central display may black out and not recover after restarting the touchscreen; and/or2. There may be loss of cert…
The boot's power liftgate may partially lower unexpectedly from the fully opened position when the vehicle is parked facing uphill on a slope in high ambient temperature.
The operator's manual misrepresents some of the situations that lead to automatic engagement of the park position 'P' (Auto-P function).The park position is engaged automatically o…
The upper anchor point for the seatbelt for the left hand side third row seat (C-D pillar) has not been installed correctly. The plastic trim covering the fixing hole and the body…
The convertible roof can be activated using the key fob at distances greater than six metres.
The welded joint on the actuator plate may fail during use.
The rear spoiler located above the tailgate may have been manufactured outside specifications. The upper shell of the rear spoiler may not have been welded or may have been welded…
The wiring harness for the horn may not be durable enough and could break due to vibration at a certain engine speed range, preventing the horn from operating.
There may be leakage from a hydraulic line connection on the steering gear, which may result in the gradual loss of steering hydraulic fluid.
The lock symbol embossed on the operating lever for the child safety lock may show the locking status incorrectly.
A gearbox oil pipe may have been incorrectly welded, which can result in a transmission oil leakage.
A gearbox oil pipe may have been incorrectly welded which can result in a transmission oil leakage.
Due to an improper manufacturing process, the front brake pad material may separate from the brake pad.
A manufacturing defect may cause the windshield wiper arm head joint to strip.
Brake caliper mounting bolts may not provide adequate clamping force between the brake caliper and brake anchor plate.
The outer section of the front grille air deflectors could detach partially or entirely from the inner section of vehicle. Clips could slowly detach due to the wind loads and addit…
Due to a possible material failure of the rear brake line as a result of overheating , the rear brake system can fail.
One of the nuts connecting the brake booster to the vehicle's frame may be missing, which could lead to reduced brake performance.
The reverse lights may stop working due to a wiring harness located at the back door losing electrical contact over time.
The gear position switch used may provide an inaccurate signal, which can lead to an incorrect gear being displayed in the rider display.
The support which holds the brake mechanism may break in emergency braking situations.