Every safety recall published by the Australian government, searchable and filterable.
During vehicle assembly, Toyota brake fluid contains polymers that act as a lubricant for certain brake system components. If the replacement brake fluid used has insufficient poly…
The fuel suction tube assembly is located in the fuel tank and incorporates the fuel pump and wiring power supply.The fuel pump wire harness insulation has insufficient flexibility…
These vehicles have been equipped with front bottom suspension arm cam-bolts that may be out of specification.
Engine oil from the brake vacuum pump may enter the brake vacuum line, possibly allowing oil to enter the brake booster.
Engine oil from the brake vacuum pump may enter the brake vacuum line, possibly allowing oil to enter the brake booster.
Engine oil from the brake vacuum pump may enter the brake vacuum line, possibly allowing oil to enter the brake booster.
The outer steering arm bolt, that secures the steering arm to the knuckle, did not receive sufficeint heat treatment during the manufacture process.
On the vehicles affected there is the potential for the retractable ‘B’ mechanism to become corroded. In extreme cases, this may lead to flying ‘B’ mascot not retracting when stru…
When the motorcycle is ridden with either the Genuine Yamaha Accessory Aluminium Top Case (23P-W0754-00) or a similar aftermarket product, the Base box may develop a crack and even…
During manufacture incorrect headlights (left hand drive version) may have been fitted to the vehicle.
When the vehicle is frequently accelerated and decelerated quickly on severely corrugated roads that specifically feature large numbers of cattle grid crossings, the rear tailshaft…
The brake tube(s) on your vehicle may have been built with an improperly formed flare that could cause brake fluid leakage.
The in-tank electric fuel pump may not be correctly activated following a vehicle start-up cycle.
On certain Land Cruiser Saraha 100 and Lexus LX470 vehicles, the construction of the steering shaft is such that the snap ring on the shaft may disengage when the vehicle experienc…
The front suspension may cause the brake hose to come in contact with the front brake rotor resulting in damage to the brake hose.
The integral clip-tabs on the decorative hood louvre may break causing the louvre to lose its retention mechanism. As the clip-tabs break, the louvre may rattle against the hood.
Due to the possibility of interference between the power steering box worm shaft oil holes and oil seal on affected trucks, the oil seal may fail.
During production it is possible that the seat belt anchor bolts at the B pillar and seat base may have received an incorrect torque setting. In the case of an incorrectly tensione…
There is a possibility that the front seat belt buckles may have been damaged during manufacture.
The accelerator pedal on your vehicle may stick during vehicle operation.
The plastic material coating the outer race of the power steering pump belt tensioner pully is of insufficient durability.
Isuzu Motors Japan have identified that the trailer parking brake air line may leak.
The ball joint and cylinder pin on the gear shift lever may be mounted with an incorrect torque which can lead to the ball joint coming loose.
During Manufacture the bolts attaching the ball joints to the front suspension upper arms on either side of the vehicle may not have been installed with sufficient tightening torqu…
Investigations have identified early wear on the the belt tensioner.