Every safety recall published by the Australian government, searchable and filterable.
The driver could experience abnormal noise from the front of the vehicle during low speed manoeuvring. In rare cases, this may indicate a fatigue fracture in one or both of the st…
Affected vehicles have been fitted with incorrect size tyres.
The passenger air bag warning label was not fitted to the left side of the dashboard.
The panoramic sunroof glass may have been damaged when fitted to the vehicle. A damaged sunroof glass may fracture unexpectedly when the vehicle is parked or being driven.
Under certain applications, heat generated by the engine may degrade air brake lines that are within close proximity to the turbocharger.
Transmission oil cooler hose clamps may detach due to the inappropriate shape of the hose clamp.
In rare circumstances, the wheel hubs and and wheel bearings on the rear axle may break.
In isolated cases, the accelerator pedal may contact the floor mat, which could interfere with the pedal operation and affect the ability of the driver to slow the vehicle.
Some rear wheel rims of the scooters are too thin around the centre splined section. This may affect scooters sold from August 2011 to August 2012.
It has been discovered that the vehicles' engines have two gaskets that contain bonded asbestos fibre.
The axle U-bolt nuts may have been installed with the incorrect torque setting.
The suspension level sensor may be faulty and may cause the rear suspension to stiffen. In isolated cases, this may affect the handling and ride characteristics of the vehicle.
There is a possibility that the electric motor installed in the hybrid system water pump may stop functioning, leading to illumination of various warning lights on the instrument p…
Due to improper heat treatment of some drive chain outer plates, some of the plates may have excessive hardness. This may lead to fracturing of the outer plates, causing the drive…
There may be inadequate clearance between the engine cover and the cruise control cable, which could allow the engine to be stuck at full power when the accelerator pedal is fully…
There may be inadequate clearance between the engine cover and the cruise control cable, which could allow the engine to be stuck at full power when the accelerator pedal is fully…
Due to a programming error, the transmission control module may not detect the position of the gear shift valve if stuck in the wrong position.
Suzuki Motor Corporation has identified that the incorrect noise label was fitted during production. The label fitted is not for this type
The sliding electrical contact module in the driver’s-side power window master switch may exhibit a “sticky” feel during operation. This is due to the non-uniform application of l…
Defective secondary spring on the pedal return mechanism.
The tow bar assembly fitted to affected vehicles may develop weld fracturing around the towbar tongue.
It has been discovered that the gaskets listed contain a small amount of bonded asbestos fibre.
It has been discovered that the gaskets listed contain a small amount of bonded asbestos fibre.
The product's identification plate displays the incorrect vehicle category. In addition, the headlamp may not meet regulated requirements and the noise label fitted to the scooter…
The following defects may occur:Exhaust Valve Bowden Cable Heat Protector: Under extreme conditions, the plastic protector could melt or burn, producing smoke and noxious fumes.St…