Every safety recall published by the Australian government, searchable and filterable.
There is a possibility that the oil level in the rear differential is not within specification.
The charge air cooler (CAC) hose can detach from the charge air cooler resonator.
The ABS unit for the brakes may contain aluminium debris due to a manufacturing error.
High stress may cause a propogating fatigue crack and breakage of the right hand front driveshaft.
Following an 'in-service' rear wheel alignment, it is possible that the adjustable rear suspension arm may be insufficiently tightened.
There may be a defect in the tyre pressure monitoring electric control unit that could cause it to give a false reading.
In the affected vehicles, if the front tyre(s) are subjected to a large external force such as running over a large pot hole or bump in the road at high speed, there is a possibili…
In the affected vehicles, if the front tyre(s) are subjected to a large external force such as running over a large pot hole or bump in the road at high speed, there is a possibili…
The unique vibration characteristics of this particular model can cause resonance that may affect the operation of the Back Angle Sensor. If the sensor is affected, it can cause th…
Possible contact between the fuel return pipe and the fuel filter support bracket.
Due to insufficient tightening of the fuel pressure sensor connected to the engine fuel delivery pipe with Nickel Phosphorus plating, there is a possibility that, over time, the pr…
The rear propeller shaft guard fitted does no meed the Australian Design Rule (ADR: 58.21*) due to a lack of propeller shaft guard rigidity.
Conformity of fitting of the windscreen side trim. In rare cases the fitting of the trim on the windscreen side trim may come loose.
Loss of communication from the steering wheel mounted controls.
On 2.4 litre single cab and GL model cab chassis vehicles fitted with sports seats, the compliance plates may show an incorrect seating capacity of 3. The correct seating capacity…
The eligible units have been supplied with a mounting bracket and side reflectors that do not comply with Australian Design Rules.
The Manufacture Date stamped onto the compliance plate is stamped with the incorrect information. The correct Month and Year must read 03/07.
The Manufacture Date stamped onto the compliance plate is stamped with the incorrect information. The correct Month and Year must read 03/07.
It is necessary to check that the anchoring of pipes is performed by using the specific clips on the bodywork.
The spare wheel in the FDi30 SX and SLX variants are fitted from factory with a steel wheel and 185/65 R15 tyre. The road wheels on the SX variant are 195/65R15 steel wheels and th…
Clutch and front and rear brake shoes may contain asbestos.
The existing labelling of the Jack does not fully comply with the requirements of the mandatory consumer product safety standard for vehicle jacks based on Australian/New Zealand S…
The incorrect Compliance Plate Approval (CPA) number was embossed on the compliance plate.
Warning label missing on the spare wheel.
Kenworth has received reports that battery and toolbox covers on some K104B models can become inadequately secured and come adrift of the vehicle while driving.