Every safety recall published by the Australian government, searchable and filterable.
Defective Rear Brake Pedal Assembly - The Pedal Lever Hub May Separate From The Master Cylinder Lever Thus Affecting Rear Brake Performance.
The Throttle Cable May Become Detached From A Bracket On The Engine.
The Outer Casing Of The Bushes Fitted To The Front Lower Control Arms May Split And Partially Dislodge From The Arm Which May Result In Unstable Steering.
A Crack May Exist In The Seam Of The Secondary Fuel Filter Resulting In Fuel Leakage.
Replacement Of Bolts On The Steering Arms On The Front Axle.
Due To Improper Assembly Of The Terminal Of The Starter Magnetic Switch (solenoid) An Electrical Short Circuit May Occur Resulting In An Under-hood Fire.
The Fuel Damper May Come Into Contact With A Brake Line (near Brake Master Cylinder) Resulting In Damage To The Brake Line To The Extent That Fluid Can Escape.
Possibility Of Damage To The Fuel Tank Solenoid Valve Exists Resulting In Tubes Breaking, Allowing Fuel To Leak Causing A Fire Hazard.
Carton Of 9mm Repair Cord Used To Patch Pit Marks In Existing Tyres Was Defective Resulting In Retreading Failing Causing An Accident.
While In Operation 4th Gear Does Not Engage Correctly And May Possibly Break Resulting In The Rear Wheel Locking Up.
The Child Restraint Anchorage Attached To The Rear Parcel Shelf In A Sedan Or The Rear Panel In A Hatch May Not Have Been Welded Correctly.
Static Electricity In The Steering Wheel Housing Which Can Occur In Certain Weather Condition, May Cause The Airbag To Deploy Inadvertently.,
May Have A Condition Wherein The One Way Valve Situated In The Brake Bootster Vacuum Hose May Not Operate Properly Resulting In Reduction In Braking Performance.
The Main Battery Cable Can Contact The Edge Of The Body Panel In The Boot Area Resulting In Damage To Cable Insulation Resulting In Short Circuit.
Brake Pulls To One Side Due To Corrosion In Adjusting Device.
Fault In The Actuator.
Bolts Securing The Shock Absorber Bracket May Fail Or Become Detached And May Interfere With The Steering Linkage Limiting Steering Movement.
The Steel Braided Tether Of The Safty Belt Buckle Is Being Deformed And Could Quite Possibly Be Cracked Which Happens As The Seats Are Being Moved.
Stress Corrosion Cracking And Bending Fatigue Can Occur Causing Sway Bar Arm Studs To Fail Resulting In Reduced Directional Stability Of The Truck.
Supplier Of The Handbrake And Clutch Fittings Did Not Always Secure The Adjusting Screw Adequately At The Brake Master Cylinder And Clutch Piston.
Brake Valve Malfunction.
Brake Fluid And Seat Belt Warning Lights Do Not Work.
Leaking Fuel Pump Mounting Plate Seals.
Retaining Clips May Foul And Damage The Inlet Fuel Hose.
The Front Left Hand Brake Pipe May Not Have Been Correctly Fitted Resulting In Decreased Clearance Between Brake Pipe And Upper Control Arm Of The Suspension.