Every safety recall published by the Australian government, searchable and filterable.
Potential For Loss Of Oil Pressure Causing Engine Seizure Which Could Lead To A Loss Of Vehicle Control.
Electrical Ecm Incorrectly Programmed Which May Cause The Makchine To Surge Forward Upon Startup.
Cracks Or Other Defects Could Exist In The Rear Axles Which Could Lead To Possible Failure.
A Warning Label Was Not Fitted To The Vehicle. The Label Specifies The Correct Type Of Brake Fluid To Use For The Braking System.
The Drive Coupling Between The Lh't' Box And The Vehicle Steering Box Can Become Loose Which Would Cause The Spines To Wear And Possibly Slip, Which Could Lead To A Loss Of Steerin…
The Wheel Retaining Bolts May Not Be Compatible With The Wheel And The Wheel, As A Consequence, May Loosen And Could Come Off.
The Incorrect Marking Related To The Maximum Machining Size Cast On The Outside Diameter Of Each Drum. The Maximum Machining Size Applies When The Drum Is Removed From A Vehicle…
Some Vehicles Within This Range Were Built With A Fuel Tank Vent System And A Bank Angle Switch That Could Malfunction. Either Of These Conditions Could Cause The Engine To Stall…
Failure Of The Fixing Stud In The Front Axles Can Occur And If Not Attended To The Second Stud Could Fail Leading To Loss Of Directional Control Of The Vehicle.
Starter Cable Interference Which May Result In Electrical Arc And /or Short Circuit.
The Existing Label Containing Tyre Information Located On The B Pillar Contains Incorrect Information.
Due To Incorrectly Machined Clutch Hub Nut, Positioning Tabs Of One Or Both Of The Springs In The Clutch Assembly May Break And Cause The Rider To Lose Control Of The Motorcycle.
The Fuel Hose From The Fuel Filter To The Throttle Is Protected By A Sleeve. Abrasion Of This Sleeve Can Cause The Hose To Leak Resulting In Fire Or Personal Injury.
Failure Of The Power Steering Pump Pulley May Occur At Low Kilometres As A Result Of Fatigue Cracks. In The Event Of Failure The Serpentine Drive Belt Will Be Subject To Damage R…
The Sealing Plugs In The Cylinder Head Can Work Loose Allowing Coolant To Escape; And The Circlip That Secures The Oil Thermostat Can Work Loose Resulting In An Oil Leak Which Cou…
Possibility That A Front Seat Belt May Not Fully Engage.
Moisture may cause corrosion in driver's side airbag mechanism resulting in airbag deploying unintentionally.
Manufactured With Handlebars That Could Break.
The Engine Control Computer May Cause Insufficient Engine Vacuum Build-up Within The Brake Booster For A Duraton Of One-and-a-half Minutes After Engine Start-up Under Certain Condi…
Steering Knuckles May Have Been Manufactured In A Specific Batch Where The Casting Operation May Have Caused Casting Defects To Occur Which May Potentially Compromise The Durabilit…
The Integrity Of A Weld Used In The Rear Semi-trailing Arm Manufacturing Process May Not Have Been In Accordance With Holden Specifications And Subsequently The Durability May Be C…
Due To The Incorrect Layout Of Under-bonnet Wiring The Clearance Between The Exhaust Gas Recirculation Pipe And The Battery Cable May Be Insufficient Leading To The Melting Of The…
Possible Breakage Of The Cabin Tilt Bracket Which May Result In Severe Injury And/or Death If In Front Of The Cabin While Tilting Or When Tilted.
Potential For Loss Of Timing Chain Tension Causing Cam Timing To Become Out Of Adjustment Which Could Lead To Loss Of Vehicle Control.
The Applied Seat Belts Do Not Have The Energy Absorbing Feature In The Webbing Area.