Every safety recall published by the Australian government, searchable and filterable.
R0511: In the enent of certain frontal collisions, the Outer Rear Seat Belt webbing can contact the Rear Seat Back Hinge, and there is a possibility it can be cut by the sharp edge…
Weak belt attachment in the B pillar.
Sudden vehicle movement in a forward or reverse direction could be experienced if the accelerator pedal is pressed.
Should a failure of the brake system occur, the affected vehicle may become hard to control (pull severely to one side, depending on which system fails) under a heavy breaking situ…
A concern related to the fitment of the lower steering shaft. If ignored, this condition could result in the lower shaft becoming detached and a subsequent loss of sterring control…
A concern related to the fitment of the lower steering shaft. If ignored, this condition could result in the lower shaft becoming detached and a subsequent loss of sterring control…
There is a possibility that the welds on the rear engine stays may crack due to vibration, resulting in engine and transmission misalignment.
There is a possibility that the high pressure fuel pipe clamps may loosen due to engine vibration, resulting in fuel leakage.
Possibility that under certain conditions the trailer can lean to one side.
The sunroof glass has been incorrectly manufactured. It is possible on door closure, severe road impact or when operated that the sunroof glass may shatter.
The bolted connections on the double wishbones may come loose over time or under extreme loading.
The incorrect brake pedal was fitted to affected vehicles during production. In the worst case if a brake circuit failure occurs the pedal travel required may be impeded due to int…
The fuel tank may develop a stress crack due to metal fatigue. This could result in fuel seepage from the tank.
The possible fitment of an incorrect lower steering universal yoke.
Tyres can have a sudden loss of pressure.
Cars were supplied from the manufacturer without the required third child restraint anchorage bracket fitted to the split rear seat backrest, thereby contravening the relevant ADR.
In the suspension system of the subject vehicles, due to insufficient surface treatment prior to the painting process, the paint on the front coil spring may not have adhered prope…
The ignition switch lead wire may be damaged by rubbing due to being routed too tightly. This may cause a short circuit which in turn could cause the engine to stall.
The parking-brake lever is likely to break.
Inadequately welded seams between clamp and exhaust tailpipe are likely to break. This can cause rattling noises while driving and can result in the loss of the exhaust tailpipe if…
A defect in the transmissions may allow them to go into a 'false neutral position' even though the neutral indicator light is illuminated. If this happens the motorcycle could dro…
The cylinder seal may fail, causing the tail-lift to fall to the ground.
Due to incorrect machining the splined end of the ZF steering shaft could push through the lower yoke. If this were to occur it could lead to a loss of steering control.
A concern may exist with the correct operation of the parking lock. This concern could arise due to a loose cup plug which enables the parking pawl anchor shaft to move rearward a…
Due to insufficient retention properties of the driveshaft circlip, the left hand front driveshaft may become disconnected from the transmission under certain driving conditions su…