Every safety recall published by the Australian government, searchable and filterable.
Certain spot welds in the roof area may deviate from the specification. This deviation may weaken the brackets for the front and rear load net fixations.
The affected LPG tanks may have a service valve hand tap fitted with undersized O-rings.
There is a possibility that a heat reflective sheath may be incorrectly fitted to or missing from the brake servo vacuum pipe in the engine compartment.
The affected LPG tanks may have a service valve hand tap fitted with undersized O-rings.
The possibility that the lower steering column is not correctly flared where it is fixed to the steering column upper universal joint.
The possible non-conformity in the engine cooling fan could result in the vehicle breaking down.
The LPG service valve hand tap may have been manufactured with undersized o-rings.
It has been determined that the lower triple clamp on some Moto Guzzi California motorcylces may break.
The electrical wiring harness located at the front of the cab may be subjected to vibration/chafing damage by the inspection flap during vehicle operation.
In some vehicles, the Nipple PCV may crack or come loose of the hose resulting in an air leakage from the Crank Case Ventilation System.
When these vehicles are driven under a unique driving pattern where the vehicle is predominantly used for short journey distances, under slow driving style and light throttle appli…
Due to insufficient contact pressure in the handlebar switch connectors, it is possible for the switch contacts to overheat and lose contact.
Due to an oversight in the checking process of the Front and Rear wheel rim and hub assemblies at the factory, some nuts were identified with insufficient tightening torque.
Due to the possibility that the front suspension lower ball joint mounting bolt tightening torque may have been incorrectly set during production.
A potential problem exists with the drag link to drop link bolt which could result in the bolt becoming bent or fractured.
Replacement of two of the engine timing belt tensioners.
A potential for the fuel pump relay to open circuit resulting in the engine stalling and being unable to restart. Throughout the manufacturing process of the fuel pump relay, seal…
Potential of the power steering pump installing bolt breakage, resulting in power steering assistance loss and heavy steering. Under high speed driving conditions the power steeri…
The clamping force of the tie-rod end on the draglink arm may not be sufficient due to the slotted sleeve in the draglink not being machined long enough.
A certain number of vehicles built between 26 and 30 October 2006 may have been assembled with incorrect tyre size (90/90-19) instead of specified size (100/90-19).
Certain vehicles may have a vibration at the mounting location of the bank angle sensor which, if combined with any misrouting of various wires that impinge on the sensor or its pi…
Fuel hose comes off at fuel pump end.
The Electric Cooling Fan control unit's metal cover may not have the specified corrosion protection. Should this be the case the metal cover will experience an accelerated corrosio…
The compliance plate has been stamped incorrectly.
The software programmed into the Anti-Lock Brake System (ABS) control module may cause the rear wheels to lock up during certain braking conditions.