Every safety recall published by the Australian government, searchable and filterable.
Investigations have shown that complete unfolding and inflation of certain windowbags cannot be guaranteed in all circumstances following an accident and subsequent triggering. As…
The ball joint fastening nuts of the suspension levers may not have been correctly tightened to the correct nominal torque.
Affected vehicles may have been fitted with a non-conforming engine relay unit.
The fault relates to a possible malfunction of the seat belt retractor.
On affected vehicles, the brake light switch may have been contaminated with silicon grease during installation which could result in a high resistance at the contact point and pre…
In affected trucks, due to incorrect routing of the brake air tube connecting the air tank and brake valve, the air tube may interfere with the bracket which locates the throttle c…
The Jiffy stand that is fitted to these vehicles may have been built with a defective weld that may allow the Jiffy stand assembly to not retract as intended. This condition could…
The Speed Control Deactivation Switch may develop an internal leak which could generate sufficient heat to possibly result in an underhood fire. The potential for a fire exists re…
The Engine Relay Unit is incorrectly specified and could deteriorate over time and cause various operating faults and in rare cases may lead to the failure of other equipment.
It is possible that if an affected truck is driven at high speed for an extended period, a crack may develop in the propeller shaft centre bearing bracket/s. In such cases there is…
Investigations have shown that moisture may enter the park brake chambers causing corrosion to form on the internal springs. In extreme cases, there is the remote possibility the s…
Investigations have shown that if an affected vehicle is subjected to abnormally frequent hill starts or quick take offs, the weld between the propeller shaft spine and pipe may cr…
Certain vehicle cabs within the production range may leak causing water to enter the PDM. If water enters the PDM electrical damage may occur resulting in possible heat damage to t…
A concern has been detected relating to the stop lamp which may not operate due to the possibility of a poor connection between the stop lamp socket and the stop lamp bulb.
Internal quality audits have identified a potential problem with the front brake caliper bracket retaining bolts. The installed bolts may be too short, reducing thread engagement o…
The Vehicle Dynamics Control G sensor on the affected vehicles may have been installed in the incorrect position at the time of manufacture which may cause the VDC system to malfun…
Some components in the original fuel pump may be compromised by ethanol blended fuel.
Evobus have redefined the welding process quality, on the Turbocharger oil supply pipe manifold and banjo unions
A concern has been identified with the instrument cluster speaker that provides some of the audible warnings on certain vehicles identified within the above range. The speaker wire…
A defect may exist in the weld on the swing-arm. Under certain riding conditions the weld could crack and the swing-arm could fail, leading to a crash in which the rider could be s…
Thd driver's Side Airbag attachment within the seat assembly may not be to specification and may allow the Side Airbag to become detached.
Over a period of time the screen wiper mechanism could become defective.
FHI (Subaru Japan) have determined that the front lateral link in the rear suspension of 07MY, 08MY and certain 09MY Tribeca vehicles may crack and if left unchecked could, in time…
A concern has been identified with the fitting process used in vehicle manufacture in relation to both rear seat belt D-loops on a number of 2009MY Jaguar XF vehicles. A minority o…
Failure of two cast alloy rear suspension uprights have been reported. These failures resulted in detaching of the main wishbone mounting, and/or toe adjuster mounting from the mai…