Every safety recall published by the Australian government, searchable and filterable.
Replace the high pressure power steering hose to prevent the following symptoms: Power steering fluid (oil) leakage; heavy steering; abnormal noise when turning the steering wheel…
A possibility of excessive brake pedal travel due to ABS hydraulic unit failure/leakage.
The ground cable between the battery master switch and battery negative terminal is missing.
The O ring seal around the rear axle ABS sensor may leak causing the rear brake to be contaminated.
The O ring seal around the rear axle ABS sensor may leak causing the rear brake to be contaminated.
A loose threaded joint in the power steering plumbing in the engine bay may leak. Power steering may fail or the fluid if it contacts a source of ignition could cause a fire.
The fuel line quick connectors may not be refitted correctly in servicing. Fuel may leak and in the presence of a an ignition source could cause a fire.
The wiring loom adjacent to the foot operated park brake spring may be chaffed and short circuit.
Water ingress into the ABS control module connector block may result in corrosion to the electrical connectors, causing the ABS warning light to illuminate and rendering the ABS fu…
The affected vehicles could experience the ACE (Active Cornering Enhancement) pump banjo bolt loosening, due to insufficient torque at manufacture, and allowing fluid to leak past…
After use of the traction control system in off road conditions, longer brake pedal travel and additional effort may be required.
Some vehicles have had the hose from the foot brake valve routed incorrectly. This can cause the hose to rub through, and may have a 10mm shorter hose fitted.
Fuel leaks could occur at the fuel supply circuit. A vehicle fire could occur as a result of the fuel leakage.
Fuel leaks could occur at the fuel supply circuit. A vehicle fire could occur as a result of the fuel leakage.
Fuel leaks could occur at the fuel supply circuit. A vehicle fire could occur as a result of the fuel leakage.
When the fuel tank is totally filled fuel may leak from the fuel level unit wiring area, due to imperfect mould filling in production process of some units.
The standard design of clips on the brake pedal and booster actuating rod may not be fitted correctly.
The solenoid valve for traction control may leak allowing the park brakes to be lightly applied.
These vehicles were built without Quick Release Air Valves in the rear braking system.
The rubber fuel hose has a defect with the potential to separate from the inner lining, thereby possibly causing a fuel leak.
A truck's ABS system typically includes 4 pressure modulation valves which regulate the air pressure supply to individual brakes thereby limiting wheel lockup under severe braking…
The end cover on the service nipple side of the fuel rail, which is mounted on the engine, does not meet the Volvo specification which may lead to fuel leakage.
Under certain conditions fuel may discharge from the canister onto the ground forward of the left-hand front wheel. This condition only occurs after parking the vehicle on a down…
Possible failure and melt down of an electronic component which operates the emergency flashing lights.
Power steering rack return pipe may arc to the alternator.