Every safety recall published by the Australian government, searchable and filterable.
The Selection Mechanism Could Become Disengaged.
The Selection Mechanism Could Become Disengaged.
Ball Joints May Experience Premature Wear Causing Reduction Of Steering Control And Collapse Of Front Suspension.
Ball Joints May Experience Premature Wear Causing Reduction Of Steering Control And Collapse Of Front Suspension.
Wiper Arms Come In Contact With Engine Hood And In Some Cases Ceased To Operate.
Possible Malfunction Of Cruise Control System On 1989 Model Fltc/flhtc Ultra.
Under Severe Repeated Shock Loadings Upper Steering Arms May Develop Cracking Leading To Failure.
Incorrect Assembly Of Webbing Adjuster Could Result In Reduced Strength Of Seat Belt/increased Injury Risk In Crash.
To Check Tyre Fitment And Replace Tyre If Necessary.
Defect In Front Seats Causes Them To Unintentionally Recline Without Warning.
Positive Battery Cable Could Develop A Short Circuit Due To Chafing And Excessive Wear.
Injection Pump Throttle Return Springs May Brake Resulting In Loss Of Throttle Control.
Possible Incorrect Assembly Of The Brake Pedal Shaft Retaining Clip.
The Welded Joint Between The Stub Axle And Main Axle Housing May Fail.
Seat Belt Inertia Mechanism Jams Making It Difficult To Withdraw The Belt Which Become Uncomfortably Tight In Use.
Front Wheel Brake Components May Brake From Vibration Caused By Bump Or Severe Road Corrugations: Loss Of Front Brakes.
Incomplete Riveting On Driver's Seat Height Adjuster Mechanism: Only Vehicles Manufactured 27/7/88 - 31/8/88.
Possible Defect Of The Brake Pedal Box Assembly And Rear Brake Line: Vehicles To Be Checked And/or Corrected.
Steering Bevel Gear Assembly May Have Water Contamination Resulting In Rust Causing A Potential Steering Problem.
Sudden Acceleration May Cause Throttle To Foul Causing Motor To Continue Revving.
Some Wheels Been Incorrectly Manufactured Preventing Wheel Nuts From Being Fully Tightened: Wheel Studs May Fail.
Transverse Weld At Skid Plate Connection To Main Beam Structural Members Causing Cracking And Ultimate Failure.
Ball Stud Used In The Steering Assembly Does Not Meet Required Specifications.
Premature Deterioration Of High Mounted Rear Stop Lamps Switch: Lights Will Remain Continuously On Or Not Work At All.
Premature Deterioration Of High Mounted Rear Stop Lamps Switch: Lights Will Remain Continuously On Or Not Work At All.