Every safety recall published by the Australian government, searchable and filterable.
The Throttle Cable Attaching Nuts May Work Loose When Cruise Control Is Engaged.
The Throttle Cable Attaching/adjusting Nuts May Work Loose On Models Fitted With Cruise Control.
Incorrectly Spot-welded Parcel Shelf.
Fatigue Cracks In The Height Adjusting Mechanism In Drivers Seat. In Event Of Rear End Collison The Mechanism Could Break And Allow Seat To Fold Rearward.
Risk Of Missing Arc Weld In The Seat Back Frame For The Front Seats.
There Is A Risk That The Reverse Gear Isn't Engaged When The Ignition Key Is In Locked Position.
The Affected Tanks May Have An Inferior Seam Weld Which Could Allow Tank To Burst Under Certain Conditions.
Rear Axel Carrier Which Due To Poor Casting Process, May Fail During Service.
Vehicle Air Bags May Deploy Unnecessarily As A Result Of A Significant Impact To The Vehicle Tie Down Hooks.
The Rolls Royce Cars May Have Incorrectly Positioned Wire Within The Gearbox Acuator. The Bentley May Have Defect In Front Seat Belt Rails.
Road Wheels May Fail Under Certain Conditions.
Potential Exists For One Side Of The Seat Track Lockikng Mechanism Of The Two Front Seats To Only Partially Engage Or Not Engage At All.
May Have Been Built With A Kink In The Wire Of The Front Seat Track Locking Mechanism. In The Event Of Collision The Seat May Move Forward.
The Seat Belt Webbing Guide May Break Under Very Heavy Load And Thereby Reduce The Restraining Properties Of The Seat Belt In An Accident.
Crankshaft Position Sensor.
Defect In The Carburettor Throttle Valve Stopper Whereby Insufficient Strength May Cause Breakage Causing Valve To Lock Resulting In Loss Of Control.
When The Third Seat Is Fitted To The These Vehicles The Operator May Have Difficulty Locking The Seat Fully Down In Position.
Sudden Loss Of Engine Power, Especially While Turning, May Cause The Machine To Lose Stability And Fall Down Due To Bank Angle Sensor.
Fitted With Suspect Front Suspension Strut To Knuckle Attaching Bolts Which May Break In.
Brake Light Switch Malfunction, Corrosion In The Abs Pressure Warning Switch And Risk For Damage On Engine Oil Cooler.
Side Reflectors Not Fitted, Turn Indicator Position Incorrect, No Tyre Placard Fitted And O Compliance Plate.
Fitted With A Sub Standard Strength Seat Squab Retaining Mechanic.
The Drive Chain May Have Been Improperly Heat Treated During Manufacture.
Drivers Side Airbag Modules May Have Been Incorrectly Assembled Without An Arming Lever.
Blockage May Occur Within Or Down Stream Of The Air Dryer Allowing Air Dryer To Over Pressurise And The Cartridge Rapidly Separate From The Base.