Every safety recall published by the Australian government, searchable and filterable.
2 nuts have been deleted, under certain conditions where a tow bar has been fitted, heavy trailer loads may distort and weaken the rear bumper bar to which the tow bar is fitted.
The front brake hose may become restricted between the front fork lower yoke and the steering lock peg, which could endanger rider safety whilst the vehicle is cornering.
There is a risk of belt separation which may cause a section of the tread and belt package to detach from the tyre casing, which may cause minor vehicle damage. If this occurs, ve…
It is possible that the tongue of the seat belt may not fully engage in the seat belt buckle.
Under some loading conditions, the welding on the front seat - power recliner can separate allowing the seat back to become loose and, in the worst case, fall rearwards.
A potenial safety issue exists where the cruise control cable can become dislodged resulting in the throttle becoming partially stuck open.
The affected vehicles could experience the throttle sticking intermittently during operation; the exact point of sticking is not predictable and can result in a higher engine speed…
The emission plates located on thr rocker on 16 litre engines have been incorrectly marked during production. The plates have the wrong smoke data but the right part number. The…
The emission plates located on thr rocker on 16 litre engines have been incorrectly marked during production. The plates have the wrong smoke data but the right part number. The…
The front fork spring strut upper bolt thread may strip under extreme riding manoeuvres.
The tyre valve may fail causing a sudden loss of air.
Trucks have been shipped with an incorrectly manufactured voltage converter. The 24V to 12V reducer in the cabin passenger side roof supplying CB or radio can overheat.
The front seatbelt stalk buckles may not latch properly.
In the event of an accident with a collision impact above the triggering threshold of the airbags, it is possible that the driver's airbag may not deploy as intended.
A component within the SRS Airbag control unit may become defective. The warning lamp should, but may not indicate this condition.
The hose on the distributor which ventilates ozone may be squeezed by the high-tension cable, causing a lack of ventilation. The insides oxidize, possibly resulting in engine inst…
When the vehicle is stationary, when Drive is selected, the gearbox, without indication or warning will select Reverse when there is insufficient oil pressure in the gearbox and/or…
The front control arms have not been manufactured within the agreed specifications, resulting in the stud and nut, securing the front control arm to the spindle, to possibly lose i…
The front control arms have not been manufactured within the agreed specifications, resulting in the stud and nut, securing the front control arm to the spindle, to possibly lose i…
The front control arms have not been manufactured within the agreed specifications, resulting in the stud and nut, securing the front control arm to the spindle, to possibly lose i…
In affected motorcycles, certain transmission components may not meet Yamaha quality control standards, which could allow abnormal wear that eventually results in a broken retainin…
Due to misrouting, the horn power wire can become frayed from unintended contact with a horn bracket mounting bolt, which if it occurs could lead to exposed wire causing a number o…
There is potential for the flexible coupling and moveable hose to break if the machine is used at high revs for a sustained period.
There is potential for the con rod bolts to fail after sustained running of the engine revs near the rev limiter.
Under certain circumstances the faulty V-stay cover may allow moisture ingress, which may lead to premature failures of the V-stays.