Every safety recall published by the Australian government, searchable and filterable.
There have been instances of leakage from the return fuel pipe on ethanol-powered buses with DS19E engines.
Moisture entering the Body Builder's electrical centre.
Possible risk for the Light Control Module (LCM) to overheat.
Where an interrupted earth cable can make the current from the cabin to find its way back to the battery through the steering shaft.
This campaign consists of fitting a strengthener plate to the removable towing ring rear support. In the exceptional situation where the rear support has been strengthened it may c…
1.Non-compliance with part of clause A 6.5.8 of Australian design rule 13/00, Installation of lights & light signalling devices, which requires telltale behaviour on turn signal ma…
Turbocharger to be replaced on New R Series Trucks with D16 engines 500 & 580hp. The turbocharger has caused increased blow-by and high crankcase pressure during exhaust braking, w…
The possibility exists for the automatic transmission shift lever guide plate screw to become loose and possibly fall out, resulting in the automatic transmission shift lever movin…
BSI Software Download. This action is necessary to eliminate the possible inadvertent continuous activation of the horn after pressing the high frequency button on the vehicles re…
Download Engine ECU Software. This action is necessary to eliminate oscillation of the motorized throttle valve which, in extremely rare cases, may cause breakage of the throttle…
Software Download for Engine ECU. This action is necessary to eliminate oscillation of the motorized throttle valve which, in extremely rare cases, may cause breakage of the throt…
Rear brake master cylinder connecting rod end bearing corrosion, on the affected units. Due to improper material selection for the rear brake master cylinder connecting rod small…
Update Software in CDI Engine Control Unit. It is possible that the engine may run rough or cut out unexpectedly.
The two non-protected passenger seats, namely the seat immediately behind the bus side access door and the inboard (aisle) seat behind the driver's seating position have not been f…
A defect exists due to the possible loss of fuel pressure failure to the engine fuel system. Due to high ambient temperature and severe driving condition concluding in vibration,…
It is possible that the Park Brake pedal may contact the vehicles wiring loom. This contact may chafe the loom.
A limited number of tyres within this production range, may present, under Australian conditions of use, a risk of reduced robustness in the crown area, which may lead to a rapid l…
The Genuine Motor Accessories Premium Oil Cooler Kits, Part No. 62868-99B used on the Touring family motorcycles, have a condition whereby an oil hose can rub on the engine crankca…
A potential exists that if any of these models of motocycles are accidentally dropped onto their left hand side, it is possible for air to enter the rear brake system via the brake…
The idle control cable may become dislodged from the fuel injection system cable guide due to improper adjustment of the throttle control system. Should this occur, the throttle m…
There is a possibility that under some operating conditions the mounting bracket retaining the Sports Roof Rack may become dislodged and in the worst case the Sports Roof Rack coul…
Some windscreens may have been fitted to vehicles, where the transparency is below that permitted by ADR. The actual transparency is in the order of 64%.
A steering shaft bolt torque may be incorrect.
The plug welds that secure the muffler bracket to the muffler body can crack allowing the muffler to become loose in the bracket. The muffler could separate from the main exhaust p…
Non conformance to ADR re: location of control switch for liftable axle.