Every safety recall published by the Australian government, searchable and filterable.
ECU software download is necessary to eliminate oscillation of the motorized throttle valve which, in extremely rare cases, may cause breakage of the throttle stop. As a result, t…
Silicon oxide may be generated on the surface of the contact point. Oxidisation may cause a resistence in the circuit causing stop lamp to become inoperative.
Emissions plates with wrong smoke data have been attached to rocker covers engines DC16 03.
On some eligible units a wrong O-ring was installed on the shock absorber.
Instances have occurred where a truck's power supply has been shut down due to the roll-over sensor tripping in other than roll-over situations. Should the Battery Isolation switc…
The exhaust clamp used to secure the middle muffler to the front exhaust pipe may loosen during operation and allow the muffler to separate from the front pipe.
Cases have been reported of the intermediate droparm's nut coming loose due to the tab that secures the lock washer in the shaft breaking. The result is slack in the buses steerin…
Some 2002 affected vehicles are fitted with a ball stud bracket located on the rear liftgate window which could rotate out of position on the glass. Additionally, all affected vehi…
The affected vehicles have been fitted with an unrestricted fuel filler neck and will be recalled to have a restricted fuel filler neck fitted.
The throttle cable seal may deteriorate over time, and stick to the inner cable. If the seal sticks to the inner cable, it is possible that the engine speed may not reduce when th…
The AVCS Oil Flow control Valve. The potential safety issue is related to the possibility of an oil leak due to insufficient tightening of bolts that secure the valve cover plates…
This vehicle had a speed restriction label on the space saver spare wheel replaced due to poor adhesion of the label to the wheel.
A rear suspension unit on the affected model may have been incorrectly manufactured. The Company will replace both rear suspension units on all models affected.
Under high ambient conditions with the blower operating at maximum setting for longer periods, it is possible for the blower fuse to reach higher than anticipated temperatures.
The Turbo Return Pipe. There have been instances of the pressurised oil pipe to the turbocharger chafing against the flange on the exhaust manifold on D9 engines.
Single sensing seatbelts (vehicle decceleration only) fitted to the retractor seatbelts. The ADR requires webbing acceleration (W) sensing also.
A protective cap must be installed over two valve cover studs and the affected wiring harnesses must be rerouted.
It is possible a leak could develop from a hydraulic line of the Active Body Control (ABC) system between the pressure supply valve and the front/rear axle distributor unit.
The park brake valve control knob could be accidently bumped and release the vehicles parking brakes.
The park brake valve control knob could be accidently bumped and release the vehicles parking brakes.
The park brake valve control knob could be accidently bumped and release the vehicles parking brakes.
The park brake valve control knob could be accidently bumped and release the vehicles parking brakes.
The park brake valve control knob could be accidently bumped and release the vehicles parking brakes.
All affected Touareg vehicles of the above chassis number range, faulty rear belt locks may have been fitted because of a riveting defect. Volkswagen will also take the opportunit…
Check Side Airbag Wiring. Correction of pin allocation for front right and front left head/thorax airbag.