Every safety recall published by the Australian government, searchable and filterable.
This recall is a re-notification for REC-005700.Due to an incorrect service diagnostic tool and software update, the affected vehicles remain with the safety defect. As a result, v…
Due to a manufacturing defect, the front passenger airbag may not have been installed correctly.
The engine support mounting bolts may not have been tightened to the correct torque potentially causing them to become loose and detach. If this occurs, the bolt will obstruct the…
Due to a manufacturing defect, the wiring that supplies power to the electric emergency braking system could contact steel components of the chassis. If this occurs, it may fail to…
Due to a durability issue, the front lower suspension arm may develop cracks and corrode when exposed to road snow melting agents. This could cause the suspension to collapse and d…
Due to a manufacturing defect, the bolt securing the brake pipe union may not have been tightened sufficiently. This could cause the brake fluid to leak and result in reduced braki…
The threaded nut securing the Antilock Braking System brake pipe may not have been tightened sufficiently and could become loose. If this occurs, brake fluid could leak resulting i…
Due to a manufacturing defect, the hydraulic brake hose for the combined brake system may stretch and separate from the fitting whilst steering to full lock. This may result in red…
Due to a manufacturing defect, there may be a crack in the body floor pan. As a result, the crack may widen. This may impact the seat anchorage performance.
Due to a manufacturing defect, the gear set within the power steering assembly may not operate as intended. As a result, the driver could experience unexpected increased steering e…
The clock spring electrical connection between the steering wheel airbag, horn and electrical systems may not have been welded to specification and possibly fail. If this occurs, i…
Due to a manufacturing issue, the heat shield between the brake master cylinder and the exhaust may have been incorrectly fitted. As a result, a connection to the brake fluid reser…
Due to incorrect manufacturing of an engine wiring harness, a poor connection may occur at the crankshaft position sensor which may lead to a loss of motive power and/or engine sta…
Due to a manufacturing issue, the sealing of the high-voltage battery housing may reduce overtime, allowing moisture to enter. The moisture may potentially result in an electrical…
Due to a manufacturing issue, affected motorcycles may lose stability whilst operating under certain conditions at higher speeds. This could result in a loss of vehicle control.
Due to a hardware component connectivity issue, the Hermes Control Unit (ECE) may not operate as intended. In this case, the communication module might not be able to establish a n…
Due to a remanufacturing process issue, the steering intermediate shaft may separate from the steering rack resulting in a loss of steering control.
Due to incomplete software update, the Advanced Driver Assistance System (ADAS) may not operate as intended. As a result, sensors and cameras yellow warning light will not illumina…
An airbag deactivation switch may have been incorrectly fitted instead of a blanking plug. This could cause the driver to assume that the front passenger airbag has been deactivate…
Due to a manufacturing issue, the motorcycle rear frame fastener may not have been adequately secured to the main frame. As a result, it may lead to a reduction of structural integ…
Due to a manufacturing defect, the right-hand tailgate and body mounted rear lamps may not be sealed sufficiently allowing moisture to enter the lamps. As a result, the reverse, br…
Due to a manufacturing defect, the vehicle body frame may have poor adhesion with the fixed panels. As a result, it may lead to a reduction of structural integrity.
Due to a manufacturing defect, the fuel pump impeller may swell and cause the fuel pump to stop working. If this occurs, the engine could stall resulting in a loss of power whilst…
Due to a manufacturing defect, the second-row seat belt buckle and lower anchor screw may become loose. As a result, the seat belt may not operate as intended.
Due to a software issue, the brake fluid warning light may not illuminate as intended to warn the driver if the brake fluid level is low. As a result, insufficient brake fluid coul…