Every safety recall published by the Australian government, searchable and filterable.
In certain circumstances the driveshaft could fail and separate at the centre bearing, disabling the vehicle.
The engine wiring harness may come in contact with components within the engine compartment; this may result in damage to the wiring harness.
Certain batches have hand brake cylinders with defective machining. This can lead to early wear of the sealing cup in the hand brake cylinder, thus leading to impaired braking perf…
Certain batches have hand brake cylinders with defective machining. This can lead to early wear of the sealing cup in the hand brake cylinder, thus leading to impaired braking perf…
On affected vehicles fitted with the 4.2L FSI engine, leaks may occur in the solenoid valve which controls the gearbox heating circuit.
A manufacturing fault in the material of the fuel pump inlet cover may cause it to swell and prevent the pump impeller from operating.
The lower lip section of the front spoiler may not have been attached to the vehicle according to specifications and it is possible that the section of the spoiler may separate fro…
The Tyre Placard may have been printed with the incorrect spare wheel and tyre size. These vehicles will not be compliant with the Australian Design Rule 42/04 - General Safety Req…
The trailer ABS malfunction light does not illuminate.
The transaxle oil pump may experience a loss of hydraulic oil pressure due to an improperly manufactured transaxle oil pump.
In the rear oxygen sensor electrical short-to-ground or short-to-battery, the sensor fails, but a Malfunction Indicator Light (MIL) or Engine Light warning does not illuminate.
The sealing performance of the oil seal of the rear shock absorber may be insufficient due to using improper grease during the shock absorber manufacturing process.
Possible non-conformity of the right front seat guide tracks.
Possible non-conformity of the right front seat guide tracks.
It is possible that the solar glass panel is insufficiently bonded to the sliding sunroof frame.
The dust gaiter/push-rod assembly in the brake master cylinder is defective.
If the electric water pump in the cooling system for the hybrid drive system fails, the warning lamp will be turned on and the water temperature may rise. If the vehicle continues…
A welded seam in the transmission dual clutch assembly may fracture resulting in a loss of drive.
On affected vehicles, it is possible that the glass panel is insufficiently bonded to the sliding sunroof frame due to the bonding surfaces not being clean during the production pr…
The bonnet secondary safety latch has a risk of being unlatched when the vehicle is in motion. Under certain conditions the bonnet can lift suddenly and block the front vision of t…
The engine may not start, or may cut out without warning. If the engine cuts out, the vehicle will lose brake power assistance and Power Assisted Steering (PAS) will also be lost,…
The engine may not start, or may cut out without warning. If the engine cuts out, the vehicle will lose brake power assistance and Power Assisted Steering (PAS) will also be lost,…
An incorrect propeller shaft angle causing a risk of the universal joint overheating and breaking.
The clutch pressure plate bearing may fail when operated frequently. The oil pump drive gear may break due to excessive stress.
The resistance of the insulated base of the Motor Control Unit (MCU) may increase. As a result the circuit voltage may become unstable, causing the malfunction lamp to illuminate a…