18 safety recalls published for the Hino Hino 300 Series (2010–2025).
Due to a manufacturing defect, the spare tyre carrier connection bolts may not have been fastened with sufficient torque and could become loose. As a result, the spare tyre and car…
Due to a software defect, a warning message that indicates when the Automatic Clutch Unit (ACU) motors require replacement may not operate as intended. This may cause the ACU to st…
The starter Emergency Control Switches enables the vehicle to be started whilst in gear. In the event of an Automated Manual Transmission (AMT) malfunction, using these switches wh…
The rear axle housing may have been assembled with an inclined flange and stress may be applied to the axle shafts and/or the hub bearings, resulting in failure.
Airbag inflator: As it gets older, a combination of high temperatures and humidity can cause the airbag inflator propellant to degrade. If an affected vehicle is involved in a coll…
The Automatic Clutch Unit (ACU) has two motors that operate the clutch. The ACU motor may not operate correctly if wear occurs on the internal brush. If one motor fails, the other…
Airbag inflator: As it gets older, a combination of high temperatures and humidity can cause the airbag inflator propellant to degrade. If an affected vehicle is involved in a coll…
The parking brake lever may not engage correctly when the lever is pulled up because the teeth in the ratchet mechanism may balance on the tooth tops.
The front passenger airbag inflator may be susceptible to moisture intrusion over time due to insufficient protection against moisture absorption into the propellant.
The instrument panel brace may interfere with the wire harness. This interference may cause the wire harness to become damaged by the edge of the brace, causing a short circuit.
The fuel filter element installed on the engine may crack if the engine is started and stopped frequently as durability of the fuel filter element is not enough to endure changes i…
In the ACU (Automatic Clutch Unit) of the transmission of the Hybrid trucks equipped with AMT (Automatic Manual Transmission):1) The water sealing grommets may be deformed and caus…
In the subject vehicles, the fuel filter element installed on the engine may crack if the engine is started and stopped frequently as durability of the fuel filter element is not e…
In the subject vehicles, the bolts and nuts fixing the centre bearing support bracket of the propeller shaft have been tightened to the incorrect torque.
The threaded end of the bolt installed on the air conditioner condenser bracket faces the slit of the corrugated tube of the wire harness and under certain operating conditions, su…
Due to an error in the casting of the steering wheel boss, the horn harness may be damaged or cut off when the steering wheel is turned.
In the affected vehicles, if the front tyre(s) are subjected to a large external force such as running over a large pot hole or bump in the road at high speed, there is a possibili…
In the subject vehicle, the brake fluid low level warning light ('Visible Indicator' in ADR35/02 S4.2) does not illuminate when the brake fluid level is below the minimum line in t…