Every published safety recall for Scania vehicles in Australia, sourced directly from the government register.
Due to a manufacturing defect, the battery wiring harness may chafe against the battery holder bracket. This may cause an internal short circuit leading to a vehicle fire.
The gearshift fork spiral pin may dislodge and move out of position leading to an internal transmission failure. If this occurs, it could result in an unintended vehicle movement.
The gearshift fork spiral pin may dislodge and move out of position leading to an internal transmission failure. If this occurs, it could result in an unintended vehicle movement.
Due to a software issue with the Electronic Management System (EMS), the vehicle may release air pollutants that exceed the standards set in Australian Design Rule.
Due to a software issue with the Electronic Management System (EMS), the vehicle may release air pollutants that exceed the standards set in Australian Design Rule.
Due to a manufacturing defect, some track rods (between left and right wheel of the steered axle/s) were manufactured without the slots at the end of it. If the slot is missing, th…
In some vehicles, the nut holding the cab tilt cylinder has not been tightened. Because of this, the cab may fall forwards when it's tilted.
If the control handle is released and bounces back after activating the parking brake, the brake system may interpret this as a request to release the brake.
The AEB software for vehicles without a tachograph has not been downgraded.
Due to a deviation in the processes of the supplier, there is a risk that backrests have been supplied with lower durability.