Every published safety recall for Nissan vehicles in Australia, sourced directly from the government register.
Due to a manufacturing defect, the fuel pipe may chafe against the support bracket and become damaged. If this occurs fuel may leak, potentially resulting in loss of motive power w…
Due to a manufacturing defect, the fuel pipe may chafe against the support bracket and become damaged. If this occurs fuel may leak, potentially resulting in loss of motive power w…
Due to incorrect Battery Management System (BMS) software calibration, the calculated battery state of charge may rapidly fluctuate. This may cause the vehicle to activate limp-hom…
Due to a manufacturing issue, the front seat belt webbing material may have been damaged or lightly scored during assembly.
Due to a manufacturing defect, the wiring harness near the 12-volt battery may have been incorrectly assembled. As a result, the harness retaining nut can become loose and increase…
Due to a manufacturing issue, the wiring harness behind the front bumper may have been routed incorrectly. As a result, the pedestrian detection sensor may not function as intended…
Due to a manufacturing issue, the mounting screws on the left-hand side front bumper reinforcement bracket may not have been tightened sufficiently. As a result, the pedestrian de…
The internal circuit board of the winches remote control can corrode if exposed to water. If corrosion of the circuit board occurs, the winch can cause the cable to stop, wind up o…
Due to a software issue, the Cruise Control function may not operate as intended and could cause unintentional acceleration when deactivated.
Incorrect front and rear covers were used during manufacturing process of the vehicle owner’s manual and therefore the content provided does not match the vehicle.